Understanding the ground conditions of your site is one of the most critical steps before starting any building project. In New Zealand, geotechnical conditions vary significantly from one site to another. This variation can mean the difference between a simple, standard foundation design and one that requires costly, complex engineering solutions.
For building owners, it’s often difficult to know whether they are getting the best geotechnical advice — whether they are overdesigning and spending more than necessary or underestimating ground risks, which could lead to structural problems later. Finding the middle ground between these extremes is key to ensuring a safe, cost-effective, and practical foundation design.
This guide outlines what makes good ground, common geotechnical challenges in New Zealand, and the solutions available to ensure your project is built on a stable and reliable foundation.
The first step in foundation design is determining whether your site has good ground. If your ground is consistent and has good bearing, the foundation design is straightforward, and no special engineering requirements are needed.
In geotechnical terms, good ground refers to soil that can adequately support a building’s foundation without excessive movement or settlement over time. The New Zealand Standard NZS 3604 defines good ground as soil with a minimum bearing capacity of 300 kilopascals (kPa). This means the soil can support at least 300 kilonewtons of force per square meter.
If you are building on known, stable ground, the geotechnical assessment may be as simple as confirming this through standard testing. However, in most cases, a geotechnical report is required to identify potential risks. These reports vary in complexity, from basic investigations to detailed site-specific studies.
To find out the cost of a geotechnical report, click here.
Once you have a geotechnical report, you can assess common soil challenges and understand the best approach to foundation design.
Soft or loose soils, such as silt, peat, or loose sands, cannot adequately support a building’s weight and have a bearing capacity lower than 300 kPa. When soil bearing capacity drops below 150 kPa, it can start affecting foundation performance and lead to other issues.
Attika has worked on multiple sites across New Zealand with low-bearing soils. The foundation design varies depending on the type of building—a retail store may have different requirements than a bulk storage facility, where loads can reach 4 tonnes per square metre due to stacked one-tonne bags.
Differential settlement occurs when soil sinks at different rates across a building footprint, causing movement issues. This often happens when the layers of soil compress unevenly under added weight.
Case Study: The Bell Block area in New Plymouth is a prime example where preloading is used. In this area, the Geotech recommendations were to load the site with heavy material to induce settlement before construction begins. Once settlement occurs, the preload is removed, and the building is erected on the new surface.
Uncontrolled fill refers to randomly dumped soil, debris, or waste materials that haven’t been properly compacted or engineered. Because of its inconsistency, it can be quite challenging to accurately know how the soil will perform in all areas of the building location.
Case Study: Many industrial areas have historical fill deposits. In some cases, excavation has revealed buried debris like cars and fridges. Depending on the severity, either full removal or a gravel raft solution is used.
Some claim that lightweight, cold-formed steel structures perform better on poor ground because they weigh less. However:
While precast panels can introduce challenges, they are often necessary for fire compliance. In these cases, structural steel can:
If poor ground conditions are identified, the best approach is to involve:
By collaborating early, foundation design can be optimised for cost and performance. For example, in cases where multiple foundation options exist (e.g., piling vs. gravel raft vs. excavation), having all experts involved ensures the best value solution is chosen.